PDA

View Full Version : Facelift number plate holder


gcon45
20-10-2010, 05:20 PM
Would someone be so kind as to post up a picture of their 02>>> front number plate holder?
NSX 2000
20-10-2010, 05:26 PM
Is this any good?
gcon45
20-10-2010, 05:32 PM
Thanks for the reply mate!

You don't have any close up pictures by any chance?
Sudesh
20-10-2010, 05:43 PM
Depending on country there are a few types,

Yours should be the same as number 4 in the red highlighted section

http://i77.photobucket.com/albums/j77/icongroup/NSXPARTS/NOPLATE-1.jpg
NSX 2000
20-10-2010, 05:44 PM
Thanks for the reply mate!

You don't have any close up pictures by any chance?

That's as close as I can get using photoshop and then resizing the photo so I can post on this forum.

I have other photos of the front of the car but they are all over 2 or 3mb, so when you zoom in it's better quality.

Paul
Sudesh
20-10-2010, 05:47 PM
Going by the part numbers its also the same garnish as used on pre-facelift NSX.
gcon45
20-10-2010, 05:51 PM
Thanks chaps!

Sudesh - that confirms what I suspected.

The number plate holder on my car is one that has been adapted to fit my car.
Sudesh
20-10-2010, 05:59 PM
New OEM is expensive for what it is,

I would ask around as I know some owners have no front plates or stuck on type to the bumper, so maybe they would part with the garnish.

If you do buy new, here you go:

71105-SL0-G01 GARN,FR LIC PLATE £111,20



Thanks chaps!

Sudesh - that confirms what I suspected.

The number plate holder on my car is one that has been adapted to fit my car.
nobby
20-10-2010, 06:59 PM
FFS! :eek: :no: :( :cry:

HUK ... sort it out

DISGUSTING for a piece of moulded plastic



If you do buy new, here you go:

71105-SL0-G01 GARN,FR LIC PLATE £111,20
JQD84983
20-10-2010, 07:14 PM
FFS! :eek: :no: :( :cry:

HUK ... sort it out

DISGUSTING for a piece of moulded plastic

You clearly have no idea how much an injection mould costs to manufacture. And your payback is over relatively limited numbers.
nobby
20-10-2010, 07:54 PM
your right I dont, my knowledge of engineering is somewhat pathetic :) but i do think price's like this do take the piss and Honda need a good slap :(



You clearly have no idea how much an injection mould costs to manufacture. And your payback is over relatively limited numbers.
gcon45
20-10-2010, 08:02 PM
Sudesh - I wouldn't mind having to pay that for the holder, my only worry however is that the 2 little holes that were drilled to hold my current plate holder might be exposed with the proper holder fitted.

I don't suppose anyone has an old broken one that I could use for sizing purposes?