View RSS Feed

All Blog Entries

  1. Gauge Cluster - Capacitor Replacement

    Introduction
    The Gauge Cluster suffers from ageing capacitors as many ECUs in the NSX do. Leaking capacitors at the gauge cluster is a serious issue. Acid near the warning indicator circuit causes shorts and even potentially lead to a fire. Same as with the other capacitor issues, a replacement should be considered before the unit fails.

    Diagnostic
    First signs are a non-accurate speed indication or a permanently lit brake light warning even though bulbs and wiring are ...

    Updated 17-12-2022 at 02:41 PM by Heineken

    Categories
    Member's Blogs , Technical Information
  2. Gauge Cluster - Bulb Replacement

    Introduction

    Around the 100.000 to 150.000 km range the first illumination and indicator bulbs in the Gauge Cluster start to fail. Replacing individual bulbs isn't economical considering the effort to get the cluster out of the car. Replacing all bulbs is the preferred route (except for AT vehicles - which will be explained below).

    Click image for larger version. 

Name:	IMAG3555s.jpg 
Views:	11212 
Size:	97.7 KB 
ID:	14362
    JDM 1997 AT Cluster

    All bulbs can be replaced without disassembling the cluster, except ...

    Updated 17-12-2022 at 02:46 PM by Heineken

    Categories
    Member's Blogs
  3. Gauge Cluster

    Introduction
    The NSX's Gauge Cluster is a good example for a nice and simple design - it features a symmetric layout with one large dial on each side, accompanied by two small dials. These main functionalities are realized:

    • Speed dial (country specific labeling and range)
    • Tachometer (model specific range)
    • Temperature, oil pressure and fuel gauge
    • Shift indicator (AT only)
    • ~30 indicator lights (some model and country specific)


    Variations and Build ...

    Updated 17-12-2022 at 02:44 PM by Heineken

    Categories
    Member's Blogs , Technical Information
  4. Speaker - Repair

    Introduction
    Failure of the NSX active speakers is a common fault, especially for the early build years. The modules are class-D switching amplifiers with a MOS-FET driver bridge for low impedance (2 Ω) speakers. The amplifier can be divided into these main sections:

    • Output drivers (MOS-FET transistors) and Filter (coils)
      Transistors used are from either STMicroelectronics (ST) or International Rectifiers (I▽R) with the BOSE-internal part number 137110
      One
    ...

    Updated 12-05-2024 at 07:22 PM by Heineken

    Categories
    Technical Information
  5. Airbag (SRS) - Capacitor Replacement

    Introduction
    The Supplementary Restrain System (SRS) ECU suffers from ageing capacitors the same way as many other ECUs in the NSX. Two things makes it a special issue: The SRS is a safety device and a permanently lit warning light means failing the regular vehicle checks in most countries.
    Especially the first generation ECUs (cars with only a driver's Airbag) tend to fail by shorting an important MOS-FET inside the housing which complicates repairs.

    Diagnostic
    Due ...

    Updated 21-02-2021 at 03:49 PM by Heineken

    Categories
    Technical Information
Page 2 of 6 FirstFirst 1234 ... LastLast