Started opening the engine. As expected, very clean TB back plate with no melted potting from the CYL/CRK sensor. Even at this low mileage and very late model, still the TB tension ...
Waited long enough so time to pour the eng oil. New filter filled with Mobil 1. Just putting everything back in place. Some owners made simple metal bar for routing the cable of the rear O2 ...
This aftermarket header is about 5mm too short for both the front and rear bank. For OEM and other manifold/header, I have to tilt the CAT during the engine installation because the stud bolts will hit the mating flange. With this header, I didn’t have to do anything because ...
Updated 24-04-2013 at 07:54 AM by Kaz-kzukNA1
Not much to report. Just a quick eng oil and filter change. Draining the old oil from the bottom and then pump out further 300 - 400cc or so from the top. ...
Updated 18-03-2013 at 02:45 PM by Kaz-kzukNA1
Lowered the rear a little and released the bushing again. Went out for further test driving session. It’s probably my imagination but the more I drive, the smoother the car felt. I quite liked it even with alignment not done yet. Hope the owner can put some mileage to settle the new kits and then re-adjust the ride height again before carrying out the proper alignment session. ...