Replaced three coolant hoses at the centre floor tunnel. All coolant hoses at the front compartment were replaced so now I can focus on the engine/Gbox installation. ...
Finished the valve clearance adjustment at the front bank. Double checked the clearance and the torque. Applied silicone grease at the metal plate of IG coil as well as the insulator tube where it ...
Due to other project, only had limited time available over the weekend so just a quick summary. Washed the valve and IG coil covers and installed the new rubber seals. So, the valve covers looked so dirty are ...
The new bolts with red sealant for the WP and thanks to my local Honda garage, the missing dowel pin was delivered. There is no point in re-using these bolts. Considering its price, it will take more time and cost to clean them thoroughly, then apply the liquid gasket one at a time than to replace all of them with the new ones. ...
Installed the new rubber seals on the TB front and rear covers. Honda upgraded the cover design after finding some of the original design with scratch marking from the cam pulley. The heat and installation method caused the cover to warp. I normally keep 1 set of upgraded design at my place in case I have to replace ...
Updated 17-03-2012 at 12:06 PM by Kaz-kzukNA1