Time for the compression check after the TB/WP/Valve service. Result in psi. Full data has been emailed to the owner. Cyl 1: **0, Cyl 2: **0, Cyl 3: **9 Cyl 4: **8, Cyl 5: **8, Cyl 6: **0 Once again, very pleased with the result. Before start of the service, there were quite big deviation between the cyl especially at the #4 cyl. After ...
Before warming up the engine in preparation for the compression check after TB service, started to clean the TH butterfly while the engine was cold. This NSX is DBW so there is no EACV, dashpot, etc. From time to time, on DBW model, you may need to adjust the idle rpm based on the specific procedure after cleaning the TH butterfly. ...
As mentioned in my last post, carried out testing of two CCU board using my NSX. In the process of Function and Operation test. Both units were fine after applying the coating so time for a test driving session. I think I’ll stop doing this CCU test driving procedure for the future as none of the unit failed during this session after passing several tests using ...
Had to be in a meeting away from my place so used the opportunity to test two CCU board using my NSX. After getting back to my place, time to vacuum fill the cooling system. Another opportunity to carry out vacuum leak check and left it like this for more than 40min. While doing this, re-installed the oil pressure ...
Cleaned and degreased the mating surface of the valve cover gasket on the engine head side. This will allow good seal around the valve cover to prevent oil seapage for many years. Applied liquid gasket to the specified section of the valve cover gasket and now Front and Rear valve covers are installed. ...
Blog Categories
Archive
Recent Comments
