However, the TB tension was way too low. If I wanted, I could have twisted the existing TB 180deg. Didn't want to put too much tension so stopped at 90deg in this photo. Most of the ...
Updated 02-09-2013 at 10:50 PM by Kaz-kzukNA1
Cam shafts removed. Quite surprised ...
It was raining, raining and raining..... Almost all day...... And it was fairly mild so the thermostat for the heater inside the garage didn’t trigger. As a result, I didn’t like the humidity of the air when assembling the internal engine parts especially around the cam shafts. The mirror finish of cam journal was fogged up even with thin coat of oil film so decided not to install the cam shafts ...
Lots and lots of blowby contaminated oil inside the oil pockets. Going to take some time cleaning the rear bank. All of the white liquid gasket from the factory ...