Recent Blogs Posts

...

Tags: coolant pipe, flywheel, gbox bolt, starter, tb tension adjuster, tb tensioner, trans bolt, valve clearance

Categories

Eng Refresh Stage 1 + LMA

...

Tags: cam pulley, tb cover plate, tb tension, tb tension adjuster, tb tensioner, timing belt

Categories

Eng Refresh Stage 1 + LMA

Before removing the TB, measured the existing valve clearance.

Out of 24 adjustments, only 7 of them were within the spec. Rest of them were all too wide.

Apart from one of the inlet valve, remaining three adjustments were just a bit too wide at #3cyl so all valve stems were fine.













...

Tags: camshaft, crank seal, tb tension adjuster, tb tensioner

Categories

Eng Refresh Stage 1 + LMA

Before/after
Looks better now although the potting will melt again.




Cam pulleys torqued carefully.

...

Tags: cam pulley, cam timing, crk/cyl sensor, cyl/crk sensor, tb tension, tb tension adjuster, tb tension adjuster bolt, tb tensioner

Categories

Eng Refresh Stage 1 + LMA

However, the TB tension was way too low.
If I wanted, I could have twisted the existing TB 180deg.
Didn't want to put too much tension so stopped at 90deg in this photo.





Most of the ...

Updated 02-09-2013 at 10:50 PM by Kaz-kzukNA1

Tags: blowby, cyl sensor, cyl/crk sensor, oil cooler, tb tension, tb tension adjuster, tb tensioner, timing belt, valve cover

Categories

Eng Refresh Stage 1 + LMA