The parking brake cable was stuck inside the L-shaped bracket on the brake caliper. And the two bolts holding this bracket were heavily corroded so I had to be really careful not to sear them off. Ill replace them with the new one on installation. If I have the time, will try separating the cable from the bracket ...
Updated 14-04-2014 at 10:53 AM by Kaz-kzukNA1 (Added parking brake cable photo.)
Bleeding of CL Hyd Sys. Unlike the brake master cyl that consists of twin piston tandem system with criss-cross flow, CL master cyl is just a single piston/line. As long as you can prime the master cyl enough, air bleeding is fairly easy and can be done with just hand operation. After priming the CL master ...
At #1 and #3 INJ base, noticed some sort of marking. #2 was dry. It's the 2nd photo ...
Just keep removing the parts in preparation for taking the engine out. Once the engine is out, its not easy to apply huge torque at the crank pulley bolt so loosen it at this stage. ...
Updated 30-10-2012 at 11:16 AM by Kaz-kzukNA1
Replaced all three coolant hoses under the header tank with new clamps. In the process of vacuum leak check on the cooling system. Left it over 40min to ...