Have been working on another NSX for several days now so catching up on updating the blog. The service menu is the Eng Refresh + LMA and based on the previous investigation on this engine, it requires the head gasket job as well. Ideally, I wanted to combine as many services as possible while the engine is out of the bay but it is important to discuss the priorities with the owner as well. So, based ...
[Edit:] Message to the owner Forgot to mention this in the previous post. Despite having the later spec LMA, to my finger, the one at the Inlet side of the #4 cyl felt tiny bit weaker than others. It is possible that it's just my imagination as I didn't measure the spring rate and just felt with my finger. Nothing to concern and won't cause noise issue probably even after the next TB service. It's the same on any ...
Updated 06-03-2014 at 03:46 PM by Kaz-kzukNA1
After cleaning the inside of valve cover, always replace the valve cover gasket, dust seal and IG coil hole seal as a set. If you order the proper kit, it also contains the metal/rubber disc washers that must be replaced every time when the fixing nuts were removed. ...
Updated 19-09-2013 at 11:18 AM by Kaz-kzukNA1
Parking brake cable holder. Looked to be coated/painted in the past but just so clean. In fact, everything is so clean. ...
Very impressed with the state of the valve covers and the cleanness of the internal ...