It was nice meeting some of you today at Japfest. As I had several higher priority projects, I was not sure whether I can attend the event or not until the very last moment so only managed to wash the car and treat the seat leather the day before the event. It seems that Liquid Leather is one of the most preferred products to treat the leather but I have never used it. There are several feedbacks on this ...
Updated 27-05-2011 at 01:37 PM by Kaz-kzukNA1
As the owner was experiencing the issue with the excessive current drain while the car was parked, the existing battery went down to completely flat several times and thus, we decided to replace it to be on the safe side. As the owner doesn’t track his NSX and also only drives it occasionally, not much point in using the racing lightweight battery. So, recently, bought the Honda ...
As mentioned in the past, although the TB itself is the same part between non-JDM and JDM NSX, JDM one will have extra items within the package and thus, uses different part no. TB installed and carefully tensioned by locking the crank shaft and tensioning each cam pulley. Once done, just check, again and again and again to make sure the timing ...
Rear bank cam shaft installed. Although the inside of the engine was not that dirty before start of the service, this will show how far the parts will be cleaned during the service. Before on the left and after on the right. About to install new TB tensioner, spring and the bolt. ...
Clean it but carefully not to scratch the cam journal by using super soft leather like cloth. Then, apply fresh engine oil around the journal, rocker, cam robe, etc. Removed the old liquid gasket and cleaned the area. Replaced the O-ring under the no.1 cam holder. ...